|
|
What makes your gears better than the rest?:
- Unlike the competition who use a material no better (or even worse) than the oem steel, all
our gears are forged from high nickel chromoly alloy which has several times the impact
resistance of the oem steel
Do you produce gears for any other makes?:
- Adhering to our strict client-confidentiality agreements, we are unable to disclose our client
details
I want a custom made gearset, can you make it for me?:
- Due to the tooling costs involved with Forged Gears, we are unable to offer custom one-off
gears. If you are inquiring about our oem service, please
Contact Us to discuss your request
I have a hydro USDM B16A/Type-R tranmission, do I have to buy a JDM 1st gear kit to fit your final drives?:
- We have USDM applications available which do not require the JDM 1st gear, needle bearing
and distance collar
Do your gears require any special fluids or additives?:
- We recommend the use of Honda MTF when our gears are installed with a stock differential
or gear type LSD. While it is not a necessity, we observe a transmission fluid change
every 2-3 Engine Oil changes. However, this is dependent on your actual
mileage and frequency of usage in competition environments. Clutch type LSD users,
please follow the recommendations of the LSD manufacturer in terms of both fluid and
change intervals
What final drive do you recommend for my car?:
- Each vehicle/driver can have very different applications, therefore in order for us to assist
you with your choice, please Contact Us and we will go
over all available options and help you select one that best suits you
I just installed a final drive and/or close gears. Do I have to break them in?:
- Our gears are fully finished and ready to run right out of the box. However, we do
recommend that an initial fluid flush be performed after 3-400miles or 1 tank of gas,
whichever comes first. The use of MFactory magnetic drain plugs is recommended
|
|
|
|
Do you offer anything for the Accord or Prelude?:
- At the present moment we do not have any chassis parts on offer for the Accord or Prelude
although we are looking into expanding into these models in future
Do you offer anything for the EF/DA Chassis?:
- Our range of rear chassis components will also fit the EF/DA Chassis. This includes the Rear Camber Kit,
Rear Toe Kit, Rear Lower Control Arms and Rear Lower Tie Bar. Our Rear Swaybar Kit will not
fit though unfortunately
Why choose Spherical Bearings over Polyurethane?:
- Unlike the cheap plastic bushings that the competition offers, by choosing Spherical Bearings,
this ensures all the benefits of multi-axis movement and near-zero deflection without the
binding and unwanted wear that is experienced with inferior Polyurethane bushings
|
|
|
|
Where are your parts made?:
- All our parts are made in Taiwan with our gears being an in-house specialty
How long have you been in business?:
- MFactory Competition Products was founded in 2004, but our staff have a collective experience
of over 15 years
What kind of warranty do you offer on your parts?:
- In short, we try very hard and take pride in the parts we produce. Unfortunately,
circumstances will arise that you may have received a part with a defect. Please give us
the opportunity to make things right with a replacement. For more details regarding our
warranty, please Click Here
How do I get sponsored?:
- Please Click Here to view our sponsorship page
|
|
